Ashley AP5660L Spezifikationen PDF herunterladen (Seite 23)

MAINTENANCE - continued

Cleaning

Heat Exchanger Tubes – Your Pellet Stove Room Heater is designed with a built in heat exchanger tube cleaner. This

should be used every 2 or 3 days to remove ash build up on the heat exchanger tubes, which can reduce heat transfer. The

handle, for the heat exchanger tube cleaner, is located in front of the vent tubes on front side of heater. Slide the rod front

to back several times to clean the tubes then follow the instructions for ash removal.

Fans – DANGER: RISK OF ELECTRIC SHOCK. DISCONNECT POWER BEFORE SERVICING UNIT

Over time ash or dust may accumulate on the blades of the circulation & exhaust fans. The fans should be inspected,

periodically, and if any accumulation is present vacuumed clean as the ash or dust can impede the fans performance. It is

also possible that creosote may accumulate in the exhaust fan therefore, this must be brushed clean.

The exhaust fan can be found behind the left side panel (facing the front of the heater), the circulation fan can be found

behind the right side panel. To access the igniter, remove the air inlet tube and cover (2 screws) (Figure 27).

Note: When cleaning, take care not to damage the fan blades.

Figure 26

Heat Exchanger

Cleaner Handle

Figure 27

Circulation Fan

Exhaust Fan

Ignitor

Auger Motor

WARNING: DO NOT ATTEMPT TO OPERATE THE HEAT EXCHANGE TUBE

CLEANER WHILE THE PELLET STOVE IS IN OPERATION OR COOLING

DOWN; WAIT UNTIL PELLET STOVE HAS COOLED COMPLETELY BEFORE

PERFORMING THIS PROCEDURE.

Periodically remove the clean outs

on either side of the heat exchanger.

Clean out the ash, then follow the

instructions for ash removal. Check

the gasket before replacing the clean

out cover. If gasket is damaged new

gasket can be ordered. Alternatively,

high temperature silicone can be used

to ensure a proper seal between the

clean out cover and the stove body.

Cover

Gasket

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 31 32

Keine Kommentare

Ashley AP5660L Spezifikationen Seite 23